Everbuild Lumberjack Professional 5 MIN Wood Adhesive - 310ml

Save £5.95

£6.95 £12.90


This wood adhesive gel from EverBuild is transparent, gap filling gel which sets hard in just 5 minutes. Particularly suitable for equipment manufacture and production line applications where rapid handling is required. 

  • Contents: 310ml
  • Approximately 225-355 ml/metre squared
  • Gap filling
  • Exterior & Interior Use
  • Acid & Chemical Resistant
  • Fully Waterproof
Technical Data & Application


  • Fast setting – 45, 30 minute or 5 minute set (Typical PVA based wood glue – 8-12 hours)
  • Exceptional bond strength to wood and most common building surfaces
  • Internal and external use - excellent weathering and aging properties
  • Fully water proof to EN204 D4.
  • Products foam slightly on application to fill small gaps and increase overall bond strength
  • Excellent Chemical Resistance

Areas For Use

  • General wood jointing and construction
  • Window and door frame manufacture
  • Door manufacture
  • Furniture manufacture
  • Construction of staircases and ladders
  • As a high quality insulation adhesive for foam/glasswool/fibre boarding


  • At least one of the surfaces to be bonded must be porous
  • Not suitable for polyethylene, polypropylene, Teflon or Nylon
  • Surfaces may be damp, but moisture content of wood must not exceed 30%w/w
  • As product expands slightly on curing, do not use on sheet laminate
  • Only apply between + 5 and + 30C
  • Ensure surfaces are always clamped during use
  • Setting times will be increased at low temperatures and low humidity

Surface Preparation
The surfaces to be glued should be clean and free from dust, grease and other contaminants.

At least one of the materials must be porous. Roughen non-porous surfaces to give a key for the adhesive. To assist cure and achieve maximum bond strength, slightly moisten one surface with a damp cloth. Do not over wet.

Cut tip of cartridge taking care not to damage the thread. Fix nozzle, cut to required aperture and apply using standard sealant gun. Wearing of gloves is recommended. Apply adhesive evenly to one surface. If necessary, cover large areas with a fine toothed spreader. Assemble parts immediately and clamp for duration of cure (5- 30 minutes at 20 c; longer at lower temperatures). After this time, the joint may be easily handled. Full and final bond strength will be achieved after 30 minutes for 5 minute set or 24 hours for 30 minute set. 

    Store in original unopened containers between 5 and 25 C. Reseal immediately once used or disposal will be necessary

    Shelf Life
    12 months in original containers at stated storage temperatures

    Customers that purchased these also viewed...

    Recently viewed