EverBuild Quick Drying Satin Wood Stain 750ml - Natural Oak - In-Excess Direct

EverBuild Quick Drying Satin Wood Stain 750ml - Natural Oak

EverBuild Quick Drying Wood Stain is a professional, low solvent interior and exterior wood stain that enhances the natural qualities of wood, and provides long lasting protection. The weatherproof protection provided by Everbuild Wood Stain also gives a crack and peel resistant finish and excellent resistance to UV light degradation.
  • Suitable for use on smooth planed exterior and interior timber, such as doors, window frames, architectural timbers, conservatories, cladding & garden furniture etc
  • Provides 5 years protection under normal weathering conditions
  • Apply with a brush, following the grain of the wood
  • For best coverage, apply 3 coats
  • Touch dry in 30 minutes, overcoat in 4 hours
  • Coverage: Up to 20m² per litre depending on absorbency of the wood
Technical Data & Application

Surface Preparation
Ensure wood is clean, dry and free from dirt or dust. Any rough surfaces or areas should be sanded until smooth. Old varnish or paint finishes must be completely removed by sanding or stripping before applying of Everbuild Wood Stain. Old wood stain finishes should be cleaned and lightly sanded to provide a key before application

Application
Stir product well before use and intermittently during application.

Brush apply Everbuild Wood Stain, always following the direction of the wood grain, approximately 3 coats will be required for full coverage. It is touch dry in 30 minutes, allow to dry for 4 hours in between coats, lightly sand the surface before applying the final coat taking care to only sand very lightly around edges.

Always apply the stain to a wet edge, working systematically across the surface keeping the wet edge moving together as much as possible. After applying to an area the finished appearance will be improved by feather brushing over the entire area with an unloaded brush taking care to follow the wood grain.

When re-coating on darker shades of stain Everbuild Quick Drying Wood Stain in clear can be used to refresh the coat without further darkening the surface. Clean brushes with water after use, a little washing up liquid will assist brush cleaning.

Limitations

  • Colour swatch label is an indication of the colour of the stain only, always test the colour on an inconspicuous, small area before full scale application.
  • Do not apply in direct sunlight.
  • Do not use on wood floors or decking.
  • Protect from frost and do not use in temps below 10°C.
  • To avoid risk of spillage, always transport this tin in a secure and upright position.
  • Do not apply in direct sunlight.
  • Ensure exterior wood/timber is treated with a non-repellent wood preservative prior to application of wood stain for complete protection. Particularly in areas subject to weathering.
  • As the manufacturer cannot know all the uses its products may be put to, it is the user’s responsibility to determine suitability for use. If in doubt, contact Technical Services Department for advice or refer to technical data sheet.

Maintenance
Inspect surfaces every 3 -5 years depending on exposure to weathering and apply top up using Everbuild Maintenance Clear coat or further Woodstain as required.

Coverage Guide
Up to 20 square metres per litre. Coverage will vary depending on the absorbency of the wood.

Storage
Store in cool dry conditions between + 5 and +25°C. Storage outside these conditions will dramatically reduce shelf life. PROTECT FROM FROST.

Shelf Life
2 years from date of manufacture when stored as directed


Maybe you'll be interested in...