EverBuild Ultra Hard Floor Varnish 750ml - Clear Gloss - In-Excess Direct

EverBuild Ultra Hard Floor Varnish 750ml - Clear Gloss

EverBuild Ultra Hard Floor Varnish is a clear, quick drying varnish ideal for use on most common types of wooden floors. EverBuild have specifically developed this product to provide an ultra-hard scratch resistant natural finish to most interior wooden floors.
  • Suitable for use in kitchens, bathrooms, lounge, dining areas or where heavy foot traffic would be expected
  • Clear, protective and non-yellowing finish
  • Apply with a brush, following the grain of the wood
  • For best coverage, apply 3 coats
  • Allow 1 hour between coats, approximately 8 hours drying time
  • Coverage: Up to 16m² per litre depending on porosity of the wood
Technical Data & Application

Surface Preparation
On unvarnished floors ensure wood is clean, dry and free from dirt or dust by wiping with a soft cloth and white spirit. Any existing coatings must be removed prior to application with a suitable sander using 120 grade abrasive paper. A suitable dust mask should be worn while sanding. Allow any dust to settle then vacuum the floor to remove any dust or debris. Fill in any holes or surface imperfections using Everbuild Multi-Purpose Wood Filler.

Existing varnished floors should be thoroughly sanded using 120 grade abrasive paper to provide a key for Everbuild Ultra Hard Varnish to be applied. Floors should be vacuumed, wiped down with white spirit and allowed to dry. Any existing varnish in poor condition should be completely removed prior to application

Application
Stir product well before use and periodically during application. Brush apply Everbuild Ultra Hard Floor Varnish following the direction of the wood grain. Apply a minimum of 3 coats allowing 1 hour between coats. Lightly sand the surface before applying the final coat. Always apply the varnish to a wet edge working systematically across the surface keeping the wet edge together as much as possible to avoid overlap.

Ultra Hard Floor Varnish can be walked on after approximately 8 hours depending on ambient temperature and conditions. Allow 72 hours before subjecting to heavy foot traffic. Do not cover with carpets or rugs for at least 7 days. Protect from water for 5 days. Clean brushes thoroughly after use with warm soapy water.

Limitations

  • Do not use externally
  • Always test in a small inconspicuous area prior to full application
  • Do not use below 10 degrees
  • Do not use in areas subject to prolonged water contact
  • Do not use on laminate floors
  • As the manufacturer cannot know all the uses its products may be put to, it is the user’s responsibility to determine suitability for use. If in doubt, contact Technical Services Department for advice or refer to technical data sheet.

Coverage Guide
Up to 16 square metres per litre. Coverage will vary depending on the absorbency of the wood.

Storage
Store in cool dry conditions between + 5 and +25°C. Storage outside these conditions will dramatically reduce shelf life. PROTECT FROM FROST.

Shelf Life
2 years from date of manufacture when stored as directed


Maybe you'll be interested in...