Johnstone's Quick Dry Primer Undercoat White - 750ml - In-Excess Direct

Johnstone's Quick Dry Primer Undercoat White - 750ml

Johnstone's Quick Dry Primer Undercoat is suitable for use on interior and exterior bare timber and masonry surfaces. The water based formulation offers low odour application and it's quick drying properties enable you to complete your job in half the time. Provides the perfect base for Johnstone's Gloss or Satin products.

  • Contents: 750ml Tin
  • Coverage: Up to 10m²
  • Can be applied with a brush or a roller
  • Resistant to cracking and peeling
  • Minimal VOC Content: 0% - 0.29% (Volatile Organic Compounds)
  • Suitable for use on both wood and masonry
Technical Data & Application

Surface Preparation
All surfaces should be clean, dry and free from grease. Remove any loose or flaking paint. Rub down bare timber and glossy surfaces with a fine waterproof abrasive paper. Avoid inhalation of dust & other substances when priming any surface.

Application
Stir well before use and apply by brush or roller to either the wooden or metal surface. Apply a liberal coat of Johnstone's Quick Dry Primer to the surface and paint in one smooth motion in one direction to achieve the best results.

Drying time

Depending on the nature & porosity of the surface, allow 4 hours drying time between coats under normal conditions.

  • Touch dry: Within 1 - 2 Hours
  • Completely dry: Within 24 Hours

    Cleaning
    Remove as much product as possible from application equipment before cleaning. Clean all equipment immediately after use with warm soapy water and rinse thoroughly to remove all paint from applicators.

    Coverage Guide
    750ml of Johnstone's Quick Dry Primer will cover approximately 10m² depending on the nature & porosity of the surface.

    Storage
    Replace lid onto the tin firmly and store in cool dry conditions between + 5°C and +25°C. Storage outside these conditions will dramatically reduce shelf life and may affect the product itself.


    Maybe you'll be interested in...