Johnstone's Speciality Paint Block Stains White - 750ml - In-Excess Direct

Johnstone's Speciality Paint Block Stains White - 750ml

Johnstone's Speciality Stains paint is great at blocking and covering stains caused by nicotine, smoke, marker pen, wax crayon, graffiti, tannin and bitumen. It provides a tough, durable matt coating which prevents stains from bleeding through. This paint can also be over coated if required with any matt emulsion paint.
  • Contents: 750ml Tin
  • Coverage: Up to 8m²
  • Can be applied with a brush or roller
  • Resistant to cracking and peeling
  • Low VOC Content: 0.3% - 7.99% (Volatile Organic Compounds)
  • Suitable for use on interior walls 
Technical Data & Application

Surface Preparation
All surfaces should be clean, dry and free from grease. Remove any loose or flaking paint. Rub down bare timber and glossy surfaces with a fine waterproof abrasive paper. Prime metal surfaces with an appropriate primer before applying this, and avoid inhalation of dust & other substances when priming any surface. Prime bare surfaces with an appropriate primer.

Application
Johnstone's paints are made to the highest standard and are ready to use straight from the tin. For the best results only apply using a brush which is fully loaded. Apply evenly around the stain allowing some over paint around the outside of the stain. Apply a single coat under normal conditions, however a second may be applied if a gloss finish is required. Apply liberally and smoothly in one direction to achieve the best results.

Drying time

Depending on the nature & porosity of the surface, allow 3 hours drying between coats under normal conditions.

  • Touch dry: Within 30 Minutes
  • Completely dry: Within 24 Hours

    Cleaning
    Remove as much product as possible from application equipment before cleaning. Clean all equipment immediately after use with warm soapy water and rinse thoroughly to remove all paint from applicators.

    Coverage Guide
    750ml of Johnstone's Specialty Paint Block Stains will cover approximately 8m² depending on the nature & porosity of the surface.

    Storage
    Replace lid onto the tin firmly and store in cool dry conditions between + 5°C and +25°C. Storage outside these conditions will dramatically reduce shelf life and may affect the product itself.


    Maybe you'll be interested in...